qua75
qua75
11-10-2019
Engineering
contestada
Cutting threads in a hole is a process called
Respuesta :
mclean112085
mclean112085
11-10-2019
Answer:
the tool is called a tap but is is threading the hole
Explanation:
Answer Link
VER TODAS LAS RESPUESTAS ( 17+ )
Otras preguntas
As the money supply increases, interest rates spending to which in turn causes O A. decrease; increase B. decrease; decrease O C. increase; decrease O D. increa
The __________ of the celebrity was obvious; he kept trying to avoid being the center of attention. Only one answer is correct. discomfiture<--- my answer
A 1.1 g marble is fired vertically upward using a spring gun. The spring must be compressed 6.2 cm if the marble is to just reach a target 16 m above the marble
A sailboat accelerates at a rate of 2 m/s? and has a mass of 800 kg. What is the net force acting on the sailboat? Answer
Solve the rational equation [tex]\frac{3x-5}{7} = \frac{4}{7}[/tex] x = −1.33 x = 3 x = 4 x = 4.67
Research confirms that aggressive patrol increases crime.
Unsaturated fatty acids are often classified according to the number of carbon atoms between the terminal methyl carbon (the omega carbon) and the closest doubl
Where does the comma or semicolon go I meanwhile will not be attending
In a group discussion, which of these conclusions is most clearly supported by evidence?Picture below.
28 points How does the poem show the theme greed can have negative consequences differently than the myth? By allowing Bacchus to refuse Midas's wish By chang
